A 15 cm Ikea Lack leg extension for the top part to be able to stack them.
19
104
0
1072
updated April 15, 2024

Description

PDF

I designed two versions, the original is designed to be tightened with a screw from the inside to have seamless corners on the outside. The second (named “Mirror”) is the opposite, where the screw holes are on the outside. After designing it myself, I found out it was very similar to @Wossi1975_403070 design, but decided not to consider it as a remix. The screw holes are 4mm in diameter.

 

If you are interested in the Leg Risers for the bottom table, Click Here.

 

Print Settings:

  • Filament: I recommend PETG, but PLA will be fine
  • Layer Height: 0.3 - 0.35
  • Perimeters: 3-5
  • Top & Bottom Layers: 3
  • Infill Pattern: Gyroid/Cubic
  • Infill Density: At least 5%, I printed with 7%
  • No supports needed
     

Tags



Model origin

The author marked this model as their own original creation.

License