SKÅDIS Pegboard Gütermann Thread Holder

Use this to hold up to 7 Gütermann thread spools (100m) and bobbins on a SKÅDIS Pegboard. 

This is a remix of the files “ISS01_Thread_stand.stl” of Skadis super easy to print sewing organizer by @Agata_1596875 (https://www.printables.com/model/804338-skadis-super-easy-to-print-sewing-organizer). The width between each upright was slightly widened so the Gütermann spools can move freely without pulling other spools with it.

Suggest using a deburring tool or knife to remove any elephants foot on the pegs that insert into the pegboard. This will help keep the spine flat and thread uprights parallel with each other.

The width between each upright has been increased by about 3mm so the spools move more freely when fully loaded. Also adjusted the position of the bottom peg by about 1mm since it was a little too tight and caused a bend in the spine.