XOL Toolhead 3DO nozzlecam mount for UHF hotends

Hi,

Before I switched over to XOL, I was using nozzlecam in SB and I was more than happy with it, so wanted to keep that feature with XOL, however haven't found ready made mounts. My CAD skills aren't great, but it fits & works.
All is based on XOL files from GIT & distance from lens to nozzle matches 3DO suggested distance.
I also made it for 3DO 4k nozzle cam, however as far as I know, knock-offs from Aliexpress got same dimensions, so they should work too.

The cam mount itself you should print flat, with or without supports where camera goes, depending on your printer settings if it's capable of this kind of bridges. Camera ribbon goes up (I used tiny bit of double sided tape to hold it), then to the right or left just below of fan and up with rest of wires. Mine camera USB board is on zip-ties, couldn't find right place to mount it.

Ducts attached are UHF, but I've only added 2.5mm ‘fins’ from camera side to prevent blinding camera by LEDs - it was terrible with original ducts, so that's not changing any properties of ducts itself & it's still printable standing, without supports.
 

Added camera mount to: 

Faceplate - LED Front 

and tiny fins to prevent blinding camera to:

- Xol LED Ducts UHF - Tri-Vane Asym Right 

- Xol LED Ducts UHF - Tri-Vane Asym Left