Galaxy S24 Ultra Case for DJI Mini Freewell Filters

This case is to help enable slow shutter speed pictures, especially in conjunction with the built in Expert RAW mode. It can also help with more cinematic blur in videos, the same as it does for the drone shots. Keep in mind that due to the filter size, it will crop the wide angle and has a slight crop on the 1x as well. This only works with Freewell filters for the Mini 3 Pro, and any other filter you know to be the same size. I only have the Mini 3 Pro so I can't test anything else.

With the solar eclipse coming up and everyone wanting to take pictures, this could help you put a dark ND filter on your phone, if you have one dark enough. Keep in mind you probably want to use this on the 5x lens and even with a filter you shouldn't point it at the sun for long as it could do damage. You might also want to tape off the other lenses to avoid them getting hot and damaged. Use at your own risk when it comes to the sun.

I made the base thicker to match, so that it will still sit flat on the table when a lens is not attached.

Since it may be hard to add supports when it's sitting on the build plate, I included a version with some supports. I tried printing this with resin and no supports, but it required some extra sanding. Hopefully these few supports will make it a little easier to sand off. I just like to print on the build plate, so if you're printing at an angle and use supports everywhere, then you can use the support free version.