Desk extension shelf

Small shelf that clamp to a desk
694
1467
4
8771
updated April 1, 2024

Makes

Comments

Task failed successfully? Nozzle right after closing the screw hole, but before finishing the top bracket. It's fine for my purposes, which is literally just to hold a tissue box.

Could you make 40x20 cm version or provide ipt file?

Just printed this today and it came out great! The only recommendation that I have is that the screws should be printed at 95% scale on the X and Y axis. The tolerances are too tight otherwise.

Material: Ender PLA
Layer height: 0.28
Supports: Yes (tree supports) but set to only at overhangs greater than 80 degrees
Infill: 20%
Printer: Ender 3 S1
Total print time: 18.5 hours
Bed adhesion: None

View one more comment

@DavidZ I dont really have weights that are small enough to test it but I would imagine that it could hold something like 30-40lbs if it were distributed properly. But with PLA I also imagine that it would potentially deform over time if it had a lot of weight on it.

@Capocaccia_1023072 thank you!! Haha I know...the small weights are the tough part. That sounds pretty durable though!! I appreciate the help!

Whats the best way to print this?

All comments loaded