EEEkit Hygrometer (Humidity Sensor) Through Screw Mount for Dry Box

This is a through-hole screw mount for a EEEkit Hygrometer (Amazon link, non-affiliate). You can use this to mount a humidity sensor for readability outside a container, but with the sensor inside.

This was designed so I could easily view the humidity inside the sealed storage container which contains my filament.

You can easily snap the hygrometer into the "outer" casing; it'll hold tight as it has tabs on the inside. Is it a perfect seal? Definitely not, but it's not bad. I printed the casing in PETG.

Included are gaskets for the inner and outer; these were printed in TPE, so they're a little squishy.

The Fusion 360 .f3d is included in case you need to make any modifications. I'll attach photos later, once it's installed.

Note: There are two gaskets, which aretechnically different size but well, there is no reason for them to be. They're interchangeable, and when printed the tenths of mm difference is irrelevant.