Suspension Bridge

Suspension Bridge multipart. The benchy is scaled 50%.

Check also Bambu profile: https://makerworld.com/en/models/388480#profileId-289273

The suspension body include auxiliary parts to allow to print cables. This parte has to be removed with a filament cutting scissors.

For printing is important to use 0.2mm in first layer and well calibrated tolerances.

x6 road stripe

x4 Pilar base

x2 lower birdge

For assembly:

1: Glue both road side and glue the white stripes in the midle

2. Glue both side of the bridge towers

3. Glue the bridge body adding the road piece in the middle

4. Insert low part of the tower in the main body to complete the bridge

5. Insert the towers in the base.

6. Carefully, with a filament scissor, cut the auxiliar part of the wires.

I suppose it should be possible to scale 150% using 0.3 layer heigh. But i havent tested it.