Bunny Phone Holder

Bunny as a toy, phone holder, keyring

Number in file names is a space for a phone in mm - numbers are also marked on the model (on the bottom)
For phone thickness of 6-16mm
If you will need other sizes you can resize any model in your slicer (preferably the closer one)
Use the equasion:
<Needed space (in milimeters)> divided by <model number> multiplied by 100% = <Needed model size in percent>

May not be suitable with phone set vertically but it depends on phone size and it's weight - mine works fine
The smaller the gap between the print and a phone the better chance it will not fall
The gap is cut with 16dgr angle but if the hole is bigger than a phone this phone will have a bigger angle (less stable)

---

If you want to sell prints of this models you can buy a commercial license
Files are without 'C47_3D' txt on the bottom
https://cults3d.com/en/3d-model/gadget/bunny-phone-holder-commercial-license

You can also check my Easter Collection (mostly Easter Eggs)
https://www.printables.com/@C47_3d/collections/142541

and a Phone Collection (some more designs for holding your phone)
https://www.printables.com/@C47_3d/collections/793008

---

To make a keyring use a Bunny model of your choice and add there a keyring model. Both models should be in the exact same position in your slicer to be sure that they will merge properly

Then merge both models

Keyring models are with a 'frame', a flat surface that will not be printed. This way it is easy to set it in the right spot with a Bunny - Ignore model 'errors' and DO NOT try to 'fix' the model

---

Models are in two versions
Normal with low poly eyes (or rather small dents ;))
and Holes with… holes instead of eyes - you can leave it like it is or put a 1.75mm diameter filament there as eyes (as on some photos)

---

Print Settings

Printed with 0.4mm nozzle
0.1mm layer height (you can use 0.2mm too)
2-3 walls
7-15% gyroid infil - may be printed without infill too. I used Prusa Slicer wich automaticly added some more walls or supporting bridges when needed
NO supports needed

---

Update 26 III 2024
Moved numbers (phone thickness) to the bottom of the model
Now they are bigger and models are little easier to print

Update 27 III 2024
Reshaped ears and a tail a little. Should print cleaner now

Update 01 IV 2024
Added 'mm' to file names with numbers to avoid rare confusions

---