Serfas Digital Shock & Tire Pump pegboard mount

Prints fine upside down without any supports

3 versions of the holder with light, medium, and strong grip. Tested in PLA and PETG

This attaches to the pegboard using cleats so it can securely attach to the pegboard. Why? Well when I would remove some of my tools, the holder would come out with it.  The video explains a lot of it.

I was able to print this without supports, but tree supports for the cleat channels may help

About the cleats

I included 2 different cleats (depending on how tight they end up printing) and the step file for them so you can modify them as needed. They print just fine without supports and I have been using PLA for it without issue (quick to print more if you break them). I also found that sometimes I needed to deburr them to get them to slide easily. But it's also kinda nice if they don't slide super easily if you are doing a semi-permeant. You can just lightly use a hammer to get them to slide all the way down.

 If they break off, Ive just used a hammer and a small screwdriver to back them out of the groove