Tapo Camera Holder Enclosure 8mm

so this is my first printer and first time dabbling in 3d software's, 

i very much liked this holder specifically because it does not use the disc holder that comes with the cam so you don't have to use any screws,

i wanted a front view so i decided to try my hand in modifying this model to fit the 8mm rods of the enclosure, first i tried blender but it is extremely complex, so i tried my luck with https://www.tinkercad.com/ and it worked

the modified model it's attached to the 8mm rods of the enclosure with 22mm zipties 

holds it's position very well and can be slid up and down easily 

the camera has full motion, connect the power cable after you set the cam in place

use manual supports under the little fins that attach the camera so you don't get supports in the holes

changed the mounting position and attachment points 

for a front view and it's attached to the 8mm rods of the enclosure with zip ties