Landspeeder Kit Card

We love the Star Wars Kit Cards by benzz88 Edabot Nakozen and delman83

After designing the millennium falcon and tie interceptor kit cards, a coworker suggested I try a landspeeder.

This was made to fit together when printed on my homemade hypercube300 printer which is not the highest precision printer in the world, so you may have to adjust the holes, or use a little glue depending on how dialed in your printer is. Adjusting the z-scale slightly up or down without changing the x & y scale can help as well.

If your filament is on the brittle side, for the front end piece and especially the windshield, it helps to try and put a little bit of a radius on the piece before attempting to snap them into place. This will help prevent a sharp bend in the piece.

Printed card is 120mm X 120mm to fit on most printers.
Assembled Model is roughly 91mm X 50mm X 27mm.

Print Settings

Printer:

Hypercube300

Rafts:

No

No

Resolution:

0.2

20%

Filament: 3D Fuel Standard PLA PLA Metallic Copper

Notes:

A good first layer is important due to all of the small holes, etc. Printer in Metallic Copper 3D Fuel Standard PLA at 30mm/s at 200C with 55C heated bed.