Customizable Tool Organizer

Made this is to stop hunting around for tools in drawers and to obviate the chaos on the desk. Ad as many sections as you need. Added LED lights and a touch toggle switch just because its fun. Connections between sections are made with Jst-PH 2 connectors.

Adafruit White LED Backlight Module - Large 45mm x 86mm
Adafruit Standalone Toggle Capacitive Touch Sensor Breakout
100 ohm resistors soldered to longer lead (+) on the LED. (LEDs wired in parallel)
Mini USB connector
M4 16mm screws
Male female Jst -PH2 connectors
24gauge cable
heat shrink tube
PLA 0.2 mm, 0.4 mm nozzle, 2 outer layers 10% infill, 20% infill for the base.

Empiricus@Dremomys

Print Settings

Printer Brand:

Wanhao

Printer:

Duplicator 6

No

Supports:

Yes

0.2

Infill:

10-20

Notes:

I was able to get 3 sections (10% infill), the bottom (20% infill) and 3 grids out of 1kg PLA.

Set overhang threshold to 60 degree. You only need support for the true horizontal overhangs. Printed this at 91.7mm/sec, design is simple and good for fast printing speeds.