Totoro Wool ball bowl

An ideal gadget for Totoro's crochet lovers. 

With this accessory you can place your ball of wool inside de bowl and pull the thread as you knit.

The original model has a circumference with a diameter of 99mm to place your ball of wool and is completely printable in PLA and without supports.

Bottom side has a hole where you can stick an 18x5mm magnet to place on any metal surface You also have another design that allows you to screw on a suction cup that has a M4 screw. This way, as you pull, the model will not slide.

I recommend to print whiskers and stick them with a little bit of glue.

I hope you like it, ¡any comments for improvement are welcome.