Simple case that works well. I did slightly modify the case to close up some of the gap above the USB ports. Haven't load tested the Pi yet to determine temperature impact, but with the vents I'm hoping it won't be an issue.
Raspberry Pi 5 NVMe HAT case (snap fit)
remix of pyrho's Pi 5 snap fit case for Pi 5 with NVMe HAT
77
1036
3
5111
updated November 30, 2024
Makes
Comments
Can you create a version that closes the gap on USB/Ethernet size of the case? Maybe replace the hole with vent slots?
Hi there is it possible to share the step files i am using the official pi m.2 tophat , and the screws from the bottom protude a bit more than yours so it closes but not that well.
Great case, thanks for modeling it! Works perfectly with my Geekworm X1001 M2 HAT. The snap fit works nicely. I added some rubber bumpers for inside cabinet doors to use as feet for the case, which stops it from sliding around due to the cable weight as RPis are prone to.
Posting this make from my Raspberry Pi 5!
Really good model. Thank you for remixing the original one. Only feedback I have would be to include more ventilation holes/cutout for the side of the case. As it is now, when I use the NVME hat on top, the only airflow for the Pi itself comes from the cutout in the rear of case, which drives up the heat for the Pi.
@amorde_2006087 Thanks for the feedback!