Deconstructed Puzzle Cube

The previous print-in-place design was quite an ambitious 36 hour print, sensitive to clearances and elephant's foot. It was a lot to ask for an all or nothing chance at success. This version is designed to be printed in separate components and assembled. The aim is to produce a version suitable for SLA printing in separate pieces, though this one is still for FDM. Print at 0.2mm layer height (less important now, only really applies to the core).

Note: Parts are in assembled position, not the ideal printed layout. I would suggest flipping the "upper" shell over. For the dials, I prefer a small support disk by enabling support interface at 100% or just print internal side down. Following over-extrusion, "Z" seams are most likely to cause binding issues with moving parts. Random Z Seam Alignment may help.

Print Settings

Printer Brand:

Creality

Printer: 

Ender 3

Rafts:

No

Supports: 

No

Resolution:

0.2mm

Infill: 

20

Filament:
eSun PLA+

Category: Puzzles