Repeating Matchstick Gun
Full printable functional Toy.
It shoots 4 matches quick in a row with Pump action to reload.
You need just a rubber band and a piece of tape.
If you have no matchstick around, i added a printable ammunition.😃
It shots awesome with good rubber band!
In the video i used a little cut from Thera Band Gold with a shrink tube.
Printing:
Printed all parts in PLA+, other materials should work as well.
There are small pieces! Clean build plate and add some glue-stick!
Layer height 0,2 works well
Assembly:
All needed parts
Important because of friction! Cut a piece of tape and roll one rotation around the rubber. You can use shrink tubing if you try with open loops and knot the rubber later.
Ready…Rubber Band with tape
Insert the trigger and the spring in a half body
Put the other side of the body on top
Slide the rubber band and the repertoire lever in.
Straddle the thin piece from the body to push over the front cap. The front cap clamps the rubber as well!
Slide the front cap into the grooves and adjust the rubber. You can wrap around several times if needed.
Load the sticks as shown..ready
You can use the really good additional Hammer for Matchstick Gun from andre.bar as well! https://makerworld.com/models/115826
=> It's easier to install the rubber-band and it shots awesome!
Dont shot on human or animals it could hurt!
Happy printing!😃👍
The author marked this model as their own original creation.