The printout is reduced in comparizon to the original size, but can be enlarged to the desired size at any time using the Prusa Slicer. Don't forget to enlarge all parts at the same time
We recommend PLA or PETG
Slicing resolution for smaller prints should not exceed 0.1mm, otherwise the figures will be blurred. 0.2 is also possible for enlarged models.
No supports necessary in the published version
…………………………
Der Ausdruck ist zum Original verkleinert, aber mit dem Prusa Slicer jederzeit auf gewünschte Größe erweiterbar. Vergessen Sie dabei nicht alle Teile gleichzeitig zu vergrößern
Empfehle PLA oder PETG
Auflösung beim Slicen bei kleineren Ausdrucken nicht über 0,1mm da sonst die Zahlen unscharf werden. bei Vergrößertem Modell auch 0,2 möglich
In der veröffentlichten Version keine Stützen notwendig
The author remixed this model.
After printing the original model, I noticed that the parts did not stay together. On closer inspection, I noticed that there was a thread in the center of the axis of the pointer, but a corresponding screw was missing. I therefore modified the size and length of an existing screw so that it would hold the two parts together.
I also decided to remove the logo on the goniometer for the remix. (but can be brought out again by discarding the negative volume)
Furthermore, it should be easy for every user of the Prusa slicer to adjust the size of the entire project to their needs.
……………………….
Nach dem Ausdruck des ursprünglichen Modells fiel mir auf, daß die Teile nicht zusammen hielten. Bei genauerer Inspektion fiel mir auf, daß im Zentrum bei der Achse des Zeigers ein Gewinde zu sehen war, eine dazugehörige Schraube aber fehlte. Ich habe daher eine vorhandene Schraube in Größe und Länge so modifiziert, daß sie die zwei Teile zusammenhält.
Überdies habe ich mir für den Remix erlaubt das Logo auf dem Goniometer zu entfernen. (kann aber durch weglassen des negativen Volumens wieder hervorgebracht werden)
Es sollte des Weiteren für jeden Nutzer des Prusa-Slicer einfach möglich sein, die Größe des gesamten Projektes an seine Bedürfnisse anzupassen.