Disassembly Tool for Glock Magazines.

This is a tool to help you open the bottom of glock OEM magazines for servicing, those little locking tabs are so stupid! 
It was a quick and dirty mod given I only had the stl to work with, but it turned out ok. 

I uses one M3 15mm. 
Still a pain to use, but at least I now have the screws for it lying around. 

This was made from thing:6194586, IronCanine's V3. 

Size sould be close to 147mm X 40mm X 8 MM
Requires no support
Print at 100% infill
Uses 13 grams
Print on flat face as it comes in.

I have found PLA+ holds up fine, but your mileage may vary. 

Changed the screw from a M4 15mm to a M3 15mm. 
Still a pain to use, but at least I now have the screws for it lying around.