Enclosure for AgOpenGPS PCBv4.xSTD v4

Enclosure for PCBv4.xSTD for AgOpenGPS. Enclosure has 2 removable sides, PCB can be inserted from both. This version is fully 3d printable. You can choose from many face and back plates available. But F9P users can only connect antenna cable from back panel. This is to make enclosure small as possible (196x125x45mm), um982 with pigtails connectors can go to front panel. There is faceplate with hole for PG7 cable gland used for additional cables like external IMU. There are faceplates version with led holes, there is plug for them that can be printed from transparent filament, or you can use transparent tape over them if visibility of leds is important. PCB slot width is 1.76mm there are models with 1.86mm.

Mounting ways: double sided tape, M6 screws x4 or x2 for panel mount version, or self tapping screws where needed.

M3 screws 12mm x8 for faceplates.