Insta360 One R Twin Case

This is a case for the Insta360 One R camera - Twin edition. It's build as a snug fit so that the camera does not move at all in the case - to avoid scratching.

Printed on Prusa MK3S, 15% infill.

Edit yours here: https://www.tinkercad.com/things/h0THbLWqcf8

Post-Printing

You might have to sand it a bit - for fractions of a millimeter to make everything fit properly.

Specially on the bottom piece, the ridge that slots into the top might need to be sanded a pit with P240 sandpaper in order to fit into the top. It's designed tojust not fit in so that - after it being sanded a bit - the box closes properly and stays closed.

Further, you might want to sand flat the ball-shaped holes for the lenses - just to make sure there are no scratches.

Lastly, the square edge around the ball-shaped holes might be also a fraction of a millimeter too snug. If the camera wobbles in the bottom part, try to sand just a bit of the edge and it should let the camera snap into place when placed.