Pen & Marker Organizer

I wanted a pen organizer that could handle thick markers, and none of the ones i could find on the market had big enough holes to handle any or other supplies like scissors - so I made this in TinkerCad - to print it, print the two pieces separately, no supports, and no raft - I recommend adding helper disks to the corners because this will warp (notice there is no bottom to the model- trust me this is to keep it from warping a ridiculous amount).

In mine I left two large holes in the center (for utility knives) and a long slot on one side (for a stapler) also the bottom has long slots for holding note pads.

Print Settings

Printer Brand:

MakerBot

Printer:

MakerBot Replicator (5th Generation)

Rafts:

Doesn't Matter

Supports:

No

Resolution:

.04

Infill:

none (you should put some in it just takes forever)

Notes:

I printed mine with zero infill, and 2 shells and it's pretty sturdy, it just takes FOREVER to print.