Magnetic Ratchet Organizer / Holder - Improved

Magnetic to attach to the metal bottom of a toolbox and hold the ratchet better.

Modular design allows for customization to your needs. 

Should fit most ratchets 1/4 inch to 1/2 inch.

1/4 inch - 14 mm wide, 3/8 inch - 18mm wide, 1/2 inch - 21.5 mm wide.

Fits 12mm x 3mm x 5mm neodymium magnets. 

Prints without supports when orientated number side down.

The integrated linking pin can be easily cut off with flush cutters.

.15mm and .2mm tolerances versions are available.

Fusion 360 models included.

Recommend at least 3 perimeters and 20% infill for strength.

Magnets can be glued in place with super glue or other strong glue, hot glue is too weak and may warp the part. 

Wrapping the magnets in electrical tape or heat shrink helps with assembly and protects the magnets. 

• Added bump-up to help hold ratchets in place
• Integrated linking pin, can be easily cut off
• Wider to accommodate more variety of ratchets
• Fits more common 12x5x3mm magnets
• Debosed/engraved ratchet-size markings