Gridfinity dual 1kg solder wire dispenser

Solder wire dispenser which fits two 1kg spools
5
22
0
139
updated February 18, 2024

Description

PDF

Just a simple solder wire dispenser which currently fits  0.25/0.5/1kg Balver spools which perfectly fits onto a gridfinity base

The spools will snap in and will not fall out if you pt the holder upside down (tested with 500g spools) 

 

Needed Hardware

per spool M3x20 screw + M3 square nut
OR
per spool M3x16 screw + M3 heat set insert
 


Print hints
 

Prints perfectly without any supports in PLA
Put Axle1 on the smaller diameter and Axle2 on the bigger diameter
Use your standard gridfinity print settings for the rest

Tags



Model origin

The author remixed this model.

Differences of the remix compared to the original

Uses the generator to generate a 5x2 60mm box

License