I made them as close the to the original as i could.
Print orientation is important!
For best results i recommend to print them on the top-side surface (it's the shorter one).
If you print them flat they feet will break easily.
Material:
PLA is fine, if you print them upright like in the pictures.
Stronger materials like PETG or ABS will be better i guess.
I used PLA and PETG, both worked fine.
Printer:
I used a Bambolap P1S: 0.20 mm layer height or 0.08mm are both really good.
A Resin printer would make even nicer parts, but i'm not sure about the feet, maybe its to brittle.
The author marked this model as their own original creation.