Lithopane Lamp with Lithopanes and Storage Base

This is a simple Lithopane Lamp with a few sample lithopanes, and a base that can store more.

To fit this lamp, lithopanes should be printed at 12cm x 12cm, with a thickness of less than 3mm, but I recommend 2.4 or 2.6mm.

The storage base can store about 8 lithopanes.  The lamp can be printed without the base, if it's not needed or wanted.

You will need a light to put in the lamp.  I do not recommend candles.  Try an LED light. :)

I had success printing these without supports.  I did a 10% infill.  Lithopanes are with 100% infill and recommend white PLA.