Stream Deck MK.2 Stand for corsair K70 MK.2 keyboard

Filament: Creality Hyper PLA

Weight: 18.54g

Layer Height: .2mm

Infill: 10% Gyroid

Supports: None

I first printed the mount made by 83metoo which was a very nice and cool design and exactly what I was looking for. Besides a few minor issues that could be fixed it was a very intuitive design that offers another great way of mounting the Stream Deck. 

Edited model is on TOP!

1. The main issues when I printed it out were that my Stream Deck (the 15 key MK.2) did not fit in the slot created as shown in the photo identified with the numbers 4 and 5. These little slots were far too tight to allow my deck to fit in so I had to both widen them as well as raise them a couple mm. I think the original width was around 3.2mm I made them around 5.2mm with a little extra space to be safe. After making those alterations it slid in very nicely. 
2. The second alteration was to enlarge the button arch labeled number 3 to allow for easier passing over the 3 buttons on the top left of the keyboard. 
3. The third alteration I made was to the hook area labeled 2 that sits just behind the row of “F” keys. It was a little too thick and if not placed right it would prevent the keys it was near from working properly because it was too close and had contact with them. To fix this I simply made the hook a little thinner and it now sits with enough space behind the “F” keys to not hinder their use. 
4. The final alteration I made was to the thickness of the base of the mount labeled 1. This portion was too thick and raised the keyboard a little bit higher than the feet at the back of the keyboard making the keyboard a little wobbly. With them being slimmer they now allow the feet to sit properly and there is no more wobble on the keyboard.