I bought a LED light to see my printer but this one was different than others so I stopped searching for one that can mount this led light and made my own. The hole for the led is 10x3x55mm fits nicely as can be seen in the images.
Printer Brand:
Creality
Printer:
Ender-3 S1 Plus
Rafts:
No
Supports:
Yes
Resolution:
0.3
Infill:
20%
Filament: Creality3D PLA+ Gray
Notes:
There is a hole for a screw if the holder is too loose so when you print it with supports you should be carefull when removing it so you dont break off one of the "legs". though I am using it without the screw because it is holding perfectly I just added it just in case it wouldnt.
Category: 3D Printing
The author marked this model as their own original creation. Imported from Thingiverse.