I designed this back along to help you glue Schumacher tyres to the rim. I tried to make the design as simple and re-useable as possible. Just print the two halfs and the clasp, may need a brim depending on your bed adhesion.
The two halves slot together and then onto the tyre, finally using the clasp to hold it all together. Glue the tyre to the rim and once set, remove.
You may need to jiggle it around in the jig slightly to get all surfaces to meet but should be ok.
Printer Brand:
Bambulabs
Printer:
Bambu P1S
Rafts:
Yes
Supports:
No
Resolution:
0.3
Notes:
PLA should be fine
Category: R/C VehiclesThe author marked this model as their own original creation. Imported from Thingiverse.