Stroller handle for your toddler

The handle is easily removable by sliding it out.

You can print the holder as a whole, or from two halves that you connect with screws. The advantage of the two halves is that they are printed completely without supports and the holder has beautiful clean lines. Dimensioned for a 20x30 mm oval stroller pole.

On the sleeve: 2x Cap screw M3x25, 2x Nut M3

For a two-half handle: 4x Cap screw M4x10, 4x Nut M4

I designed it on screws that we just had at home. Can be adjusted to your screws for your own use.