Signages

Here are some Signages which can be stuck on surfaces using either a double sided tape or magnets. Added two new!

Color change is required to get this effect while slicing!

Error

Nuclear

Biohazard

Danger 

Laser 

3D Printer

Flammable

Electric

Recommended Layer Height : 200um / 0.2mm

I have used a 5mm x 1mm neodymium magnet on the back but you can change the size of the hole according to the magnets you have.

The color change will happen at the same layer height so you can print all the signages at the same time.

If done individually, each sign should not take more than 30 minutes at 0.2mm layer height.

Thank You~