Extension Cord Reel - 50ft (15m) - Ambidextrous

Extension cord reel for 50ft (15m) cords.
35
142
0
1005
updated February 6, 2024

Description

PDF

This pushes the outer limits of the X1C's 256mm bed. It's 250mm in diameter. If you're a perfectionist, pause the print and remove the purge lines before letting the first layer go down. It's easy enough to trim it off if you don't. I used PLA+ but my next one will probably be ASA. 

Here's everything else you need to know.

Hardware

Other info

  • Make sure to use supports on the handle pieces (gray) or you're going to have a bad time.
  • You might want to print the pin that connects the knob to the side with more walls than the other pieces. I used 5 walls and bumped up my infill (gyroid) to 25% just to make sure it was strong enough. 
  • Assemble all the parts in orange first; then, the handle will be attached from each side.
  • I increased the tolerances on the threads for the center pieces. It was a super tight fit and I had to spend about 20 minutes sanding to get them to go together right.
     

Tags



Model origin

The author marked this model as their own original creation.

License