Having a little hard time printing this. There appears to a slight bend, thus not allowing the "back side" to lay perfectly flat. Im the only one with this issues?
@ragnobash_1962005 There's a slight bend? I'm not sure I'm seeing that in the 3d file. Would you be able to print it standing up? That's how I printed mine
sorry it took a better part of half a year to be back to you. I fixed the issue with printing on the back by cutting off a single layer so it now prints flat.
Having a little hard time printing this. There appears to a slight bend, thus not allowing the "back side" to lay perfectly flat. Im the only one with this issues?
@ragnobash_1962005 There's a slight bend? I'm not sure I'm seeing that in the 3d file. Would you be able to print it standing up? That's how I printed mine
@PeterTheTeac_1608838
sorry it took a better part of half a year to be back to you. I fixed the issue with printing on the back by cutting off a single layer so it now prints flat.
@ragnobash_1962005 All good, glad it worked out!