AICS Magazine Pouch Molle Version

This is a remix of the AICS Mag Holder Dropped V3 to be used with Molle system.  This is as yet untested and should be considered a work in progress.  Recommend PETG or TPU and a high infill rate for strength.  Do not recommend PLA as not suitable for field use.

This is a remix of the dropped AICS magazine holder designed to be used with standard 6 inch Molle straps.  The strap slot spacing was determined by that of straps on a USGI corpsman's pouch, which will pass through the slots as designed.  I have yet to test this print as I do not have standard 6" Molle straps on hand.  There is a picture showing it mounted to the back of the pouch as a trial fit. This should be considered a work in progress and suggestions from the print community are welcome.

I envisioned the path of the front half of the straps to go over the top of the holder, through the top slots from the front, then down the back and through the bottom slots. the back half of the 6 inch straps should hang down and be fitted through the Molle webbing on belt or other carrier.  Actual use may dictate something different and if someone has further comments, I will adjust design to suit, if desired.

I recommend using PETG or TPU, with a high infill, as that has proven to be more durable in field applications than PLA.