Sagemcom DIW7022 (2024 KPN decoder Set-Top box) wall mount

A wall mount for the Sagemcom DIW7022 set-top box, known as the current (2024) set-top box of a Dutch internet/tv provider knowing: KPN.

Holes for the screws are 3mm in diameter, with a 4mm diameter drop to hide to top of the screws.

The wall-side is made pretty beefy (18mm thick), but this fits my personal setup with the screws i had.

I've added a slotted vent pattern, to give it some air.
The set-top box should fit somewhat snuggly.

The backside should give space to fit each connector, if that is not the case, let me know ASAP, then i will edit the model. (I did not print this version myself, i'm gonna re-use my older KPN decoder mount, which this is based on)

Havn't printed this variant of the decoder wall-mount, but i've made sure it would fit according to physical size, I'm re-using the photo of the original 2021 model that i've made , hence why the photo is blurry.

Recommanded print settings:
- 0.6mm nozzle
- 4 perimeters (This makes the screw holes strong)
- 3 top and 3 bottom solid layers
- 20% gyroid infill
- 0.32mm or 0.40mm layer height (since this is a structural design, no need to make it nice)
- Supports OFF
- Every other setting is the stock Prusament PETG setting in 0.6mm nozzle config

Printing orientation: standing up on the backside. (with the side where the connecters would go to the printbed)

With the newer 2024 set-top box decoder from KPN the size changed since the last generation decoder, i've adjusted the sizing to make it fit well again.