Charger Stand for Samsung Active Watch

Two piece stand I created for my wife's Samsung Active Watch. The two pieces assemble with a M4 x 12mm screw and hex…
7
36
0
442
updated December 17, 2022

Description

PDF

Two piece stand I created for my wife's Samsung Active Watch. The two pieces assemble with a M4 x 12mm screw and hex nut for adjusting the angle. There is a slot in the top of the stand to hold the hex nut during assembly. I used a higher infill in the base (85%) to increase stability. 25% infill for the holder works just fine. I have printed this both in .1mm (pictured) and .2mm resolution successfully. I suggest using supports everywhere for the best results. Print with the base as it stands and the holder with the flat side down. Thread the USB connector through the slot in the holder and then the charger will install with a snug fit in the cavity.

Print Settings

Printer:

Maker Select V2

Rafts:

Doesn't Matter

Supports:

Yes

Resolution:

.1 - .2

Infill:

25% - 75%

Filament: Hatchbox PLA Silver

Category: Gadgets

Tags



Model origin

The author marked this model as their own original creation. Imported from Thingiverse.

License


Highlighted models from creator

View more