E34M1 Toolhead Filiment Cutter

This is an old version use this updated version that works with all hotend mounts instead
https://www.printables.com/model/1141394-e34m1-filament-cutter

For the lever spring you will need a 5x20mm spring, a smaller spring can be used but the I.D. must not be below 3 as it goes around a m3 screw to keep it in place.
https://www.amazon.com/gp/product/B09C1DDHRV/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&th=1

For the cutter you will need a #4 hobby cutting blade cut to 28mm mounted with a 3mm hex screw
https://www.amazon.com/gp/product/B07QP8L1QG/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1

It's recommended to use the LW actuator arm that mounts directly to the X gantry. You will need slightly longer m3x35 screws to secure it down as it replaces the 3 screws that is used to hold the X gantry together

Revision 1: found that screw inserts on actuator arm LW are slightly too long. Reduced the length by 1.5mm

Remade the front and belt holder to work with the Zero G Mercury movement system.