Lost Factory Cube - A generalist *diagnostic* cube

You need to print this cube:- 

• at 0.2mm layer height
• on a 0.4mm nozzle (or smaller) with 0.4-0.46 line width
• out of a non-silk material (silk expands when it comes out of the nozzle!)

The screw and rod parts snap off to test in the screw holes and normal holes. There are ghosting, overhang, cooling, ovality tests among other things. 

The license is non commercial, you may not redistribute this commercially, please link to this source. You can however show it in your videos or whatever, commercial or otherwise.