This phone holder mounts into the large center console of the Ford Transit 2020+.
* The size of the ball head varies, so phone holders other than the one above won't work.
1. Clean the surface in contact with the VHB tape:
2. Remove the protective film from the VHB tape:
3. Apply pressure (push down and against the surface) for 5-10 seconds:
4. Remove the tightening nut from the back of the phone holder and place on the mount. Push down to engage the phone holder into the ball head (tightening nut MUST be removed!):
5. Tighten the nut to provide enough friction so that the phone holder maintain its position under its own weight, but so that your are able to move it freely by hand :
6. The removable tray can be easily removed for cleaning or for picking up small objects at the bottom:
I personally use Polycarbonate for high-temp and UV resistance, strength, and good layer adhesion. But any filament other than PLA should do it.
I personally use PETG (Polylite Dark Gray) for temperature resistance, to add some flex, and because the color matches perfectly with the phone holder and dashboard!
The author marked this model as their own original creation.