Gamecube Memory Card Flap

The memory card flap from the Nintendo Gamecube console
19
136
0
306
updated January 26, 2024

Description

PDF

This was modeled to the original Gamecube design. It may not be the easiest to print because of that.

I printed with the shaft vertical as I wanted this to snap into the original location and revolve freely. Supports were used with a 0.08mm layer height.

I had to trim the two stoppers on each side as they were interfering and preventing the flap closing properly. I modified this model so these are slightly narrower, but if you notice them getting stuck, they might need trimming.

Tags



Model origin

The author marked this model as their own original creation.

License