Knog x Basil - Bike Light Holder

This solves a quite specific issue. It is an extension for you bike basket. If you are riding your bike with clip on light, that are supposed to go on the handle bar, but are also riding with a front basket, you run into the issue of blocking your front light, if the basket is packed.

That means you have to reposition the light. Best position is the front of your bike basket, as there are no other bike parts blocking your light beam. But in most cases the diameter of the rods is to small, which means you clip on light won't hold there.

I'm riding a Basil basket and Knog (Blinder) Front Lights (also a Knog Blinder Rear Light).

Adding those 3D printed pieces gives your bike light a place to stay at your basket. Positioning it at the vertical beam (thats what the indent is for) prevents it from unwanted rotation downward. But you can install it anywhere in the 9mm rod of the basket, as the fitting is quite tight.

It is designed for M3 bolts and weld in rivets (I use the ones from Ruthex).

You get 4 .stl files. It is split in right and left (as i don't attach them symmetrically above the vertical beam) and front and back piece.

The gcodes contain all the four pieces. One gcode is printed with brim, the other one (shorter print time) is without a brim. I needed the brim in order for the print to adhere properly.