This is a snap-together case for the Raspberry Pi 4 with storage slots for three additional micro SD cards. This was requested by members of the Guild of Makers, and made by a member, and so it carries the guild logo.
The RPi is attached to the lower case with M2.5 screws, which should self-tap into the screw pillars.The upper case can then snaps on top. I provided plenty of room in this case for a fan (like the fan shim).
SD cards can be slid into the slots on the side and secured by friction fit by a small bump. They are easily extracted with a fingernail.
Supports are required, but should not affect the outside appearance anywhere that matters.
Suggestions for improvements are always welcome, and an F360 file is available if anyone would like to edit it themselves.
Unassociated tags: pi 4, raspberry pi, raspberry pi 4, sd card, sd card case
Printer Brand: Prusa
Printer: I3 MK3S
Rafts: Doesn't Matter
Supports: Yes
Resolution: .2mm
Infill: 20%
Filament: Generic PLA Black
The author marked this model as their own original creation. Imported from Thingiverse.