Makita MAC700 Air Compressor Feet With Penn Championship Extra-Duty Felt High Altitude Ball's

I needed a different type of feet for my Makita MAC700 air compressor to keep the original rubber feet from rooting and the screw & washer from scratching my wood floor. I fount that https://www.printables.com/@CymenVig_234754 “The California Air Tools 1P1060S compressor antivibration feet” were to small for what I needed. This is why I created the four antivibration feet for my MAC700 air compressor.

I used these “Penn Championship High Altitude Tennis Balls - Extra Duty Felt Pressurized Tennis Balls” for high altitudes, here is the link: https://www.amazon.com/dp/B003ILP9PY?ref=ppx_yo2ov_dt_b_product_details&th=1 

I used 100% infill to make it more sturdier.

To install: 

1. Take each rubber foot off of the air compressor, don't lose the screw & washer if they come out
2. Push the rubber feet with the screw & washer thru the printed feet
3. Screw all four of the new feet back onto the air compressor
4. Insert a tennis ball into each one, then flip over

Category: Tools

The California Air Tools 1P1060S Compressor Anti-vibration Feet were set up to fit a smaller size of rubber feet. I needed a larger opening for the rubber insert goes through and that would fit a larger ball.