Altoids Sized Case with Hinge

printed a few altoid sized cases an they all were really tight fits an hard to open once closed so i jumped into tinkercad an made this case. its quite a bit taller than the altoids case but i made it to have hinges an a small latch on the front to help keep it closed. dont know how well it would do with staying closed with the small latch while in a bag or back pack, if anyone would like me to change it i can, just comment your suggestions. i printed it with supports for the hinges but i think u could print without supports if you have good part cooling.

Print Settings

Printer Brand:

Creality

Printer:

Ender 3 Pro

Rafts:

No

Supports:

Doesn't Matter

Resolution:

0.16

Infill:

25%

Filament: Geeetech PLA or PETG Black & Grey

Notes:

ive only printed it in PLA so far an my last version has held up great no issues. it can be a little stiff to put the top on, put one side in and then back out, do the same to the other while leaving the first side out and it helps with put them both in at the same time. any suggestions are welcome.