Quest 3 Facial Interface for BoboVR F2 Fan

I liked bondematt's design with the vents, but also furryWallpaper's idea with the neodym magnets, so I enlarged the holes for 5x3 mm neodym magnets.

Also, I enlarged the space in the middle to create more clearance for the head strap.

The "Deep" version is about 10mm longer on its sides, allowing for the original BoboVR F2 face pad to fit better.

Also, I added an extended Version of jayle's head strap clip which fits under the BoboVR F2. The matching version of the face mask has an extra bracket to keep the clip from popping off the F2.

You need to wedge the F2 fan a bit between the face mask and the top clip for installation, but this comes with the big advantage that it won't fall off as annoyingly easy as the original did on the Quest 2.

EDIT: Short Strap Clip

After a while of usage I noticed the face mask would come loose at times; at first I thought the clips were not precise enough, but it turned out the first version of the strap clip was just a bit too long resp. tight and pushed the face mask away from the Quest 3 when moving. 

The new version is 2mm shorter and now fits perfectly. Also, I rotated one attaching clip so both of them would face upwards, making the installation much easier. It has a slight tendency to detach from the HMD, but a small strip of adhesive soft velcro (or similar) on its underside solves this very well.

Print Settings

Printer Brand:

Creality

Printer: 

Ender-3 V3 SE

Rafts:

No

Supports: 

Yes

Resolution:

0.2

Infill: 

20%

Filament: Colido PLA Plus