Raspberry PI 5 Case - Modular Snap Together with SSD Enclosure

The TOP and BOTTOM files replace the designs from the original, They are essential the same just wider to match the SSD Enclosure. 

Also the BOTTOM has holes underneath for the SSD enclosure to clip into.

The insert for the top is the same as the original model so they are not included here.

The SSD enclosure is the only model that needs support - and only touching baseplate for the screw holes.

I printed all 4 parts in 0.28 layer height, 0.48mm line width (with a 0.4mm nozzle), 2 walls, 2 top layers, 2 bottom layers, 15% grid infill.

I didn't intend to print with 0.48mm line width! the setting was left over from a previous model… so 0.4mm line width would be fine - as would pretty much any number of walls, top/bottom and infill setting you like (as long as there is some infill).

The SSD enclosure is a tight fit to snap on and isn't designed to be disconnected. It does have screw holes to secure the ssd drive, but I didn't need to use them as the ssd drive has a snug fit.

Modified TOP and BOTTOM to match the width of the SSD enclosure.

Add SSD Case that clips into the underside of the Pi5 Case.