Hier gibt es einen Einsatz der genau in den SQ20 Rahmen von einer Janome MC550E und kombatiblen Modellen von zum Beispiel Elna passt.
Der Stoff wird mit einer Klemmplatte gehalten und nicht überdehnt. In Ober und Unterplatte sind Magnete verbaut die das ganze dann zusammenhalten.
Benötigt werden 10 Stück Neodym Magnete Ø10x2 und 10 Stück Neodym Topfmagnete 15x13,5x5mm. Die Topfmagnete kommen in die untere Platte eingesetzt ( Der Magnet muss in die Platte zeigen ) Die Rundmagnete kommen in die obere Platte. Hier ist auf die richtige Polung zu achten, das der Magnet sich an den unteren Topfmagneten anziehen kann.
Gedruckt wurde der Rahmen auf einem Prusa Mk3S+ in PETG. Hier ist zu beachten das frisch getrockenetes Filament verwendet wird und der Drucker sauber eingestellt ist. Ansonsten ist das Druckergebniss nicht so schön. Bei beiden Platten wurde mit Organischem Support gearbeitet. Die Seite mit den Öffnungen für die Magnete liegt auf dem Druckbett auf.
Auf die Rückseite wurde 1mm dicker selbstklebender Filz aufgeklebt damit der Rahmen sauber gleitet.
------------------------------------------------------------------------------------------------------------
Here is an insert that fits exactly into the SQ20 frame of a Janome MC550E and compatible models from Elna, for example.
The fabric is held in place with a clamping plate and is not overstretched. Magnets are built into the top and bottom plates to hold the whole thing together.
You will need 10 neodymium magnets Ø10x2 and 10 neodymium pot magnets 15x13.5x5mm. The pot magnets are inserted into the lower plate (the magnet must point into the plate). The round magnets are inserted into the upper plate. Ensure that the polarity is correct so that the magnet can attract the lower pot magnets.
The frame was printed on a Prusa Mk3S+ in PETG. Please note that freshly dried filament is used and the printer is set up correctly. Otherwise the print result is not so nice. Organic support was used for both plates. The side with the openings for the magnets lies on the print bed.
1mm thick selfadhesive felt was glued to the back so that the frame slides cleanly.
The author marked this model as their own original creation.