Sovol SV07 & SV07 Plus LED Bracket

I'm not sure what the difference is between the Extruder and LEDs on the SV07 and the SV07 Plus, or even if there is one but I think this should fit the SV07 too.

But if you want to remove the extruder cover to get a better view of the nozzle and what's going on, and still keep the LEDs, the best solution I found was Ben Witten's LED bracket for the SV07. 

While this bracket also fits my SV07 Plus, I've found it doesn't fit that well so I have remixed Ben's design, tweaking and reshaping it here and there so it's a nice fit for the SV07 Plus.

I had to use a 3mm drill to ream out the holes for the plastic rivets and mounting on both this and the original, you might have to too.

Printed in PLA without supports. Prints in under 40mins. 

Tweaks and reshapes Ben Witten's LED bracket for the SV07 to better fit the SV07 Plus.