Uno and Uno Emoji Box

This model prints a bit nicer (no filets on the base) and uses slightly smaller screws (m25). Importantly, the logo's are inlaid bodies, which makes them far easier to color and print. In your slicer, after importing the STL, you may need to “split to parts” to select the logo parts.

I've included the F3D files for both so you can make alterations if you need them. Probably most useful if you want to use a longer/shorter screw, otherwise you can just print from the STEP files.

The step files are built with these settings in mind:

• 3 walls
• 0.4mm nozzle
• 0.2mm layer height
• Classic slicing mode

For print setup, I found printing the lid and bottom on the same plate works fine, even with AMS material switching. I would generally put the card-holder and latches on a second plate in a single color.

Borrowed the inner card holder; inspired by the design