Raspberry Pi 3 box + camera arm for Prusa MINI front

Taken Prusa MINI Raspberry Pi 3 Case by Joe and Raspberry Pi Camera Stand by Daniel BP - then combined the arm holding the camera with RPi case, added the latch that goes under the front panel of Prusa MINI holding it even on the verge of the table. I then can have the Prusa MINI on a small table with RPi case “hanging” over the verge but not falling down, and the arm holding the camera (the length allowing for the original camera cable) for remote (OctoPrint) monitoring of the print.

Please, note, that because of this setup (RPi “hanging” and touching the Prusa case) the case is shaking during the print, so the quality of the camera pictures can be worse than from “independent” camera mounted on the table.