Datto ALTO 3 V2 Replacement Case Bottom 20mm Screws

This uses a screw size of m2.5 x 20mm and are much easier to find than the 40mm versions for the original.

This does NOT have capability for holding 2.5" drives. That version is in progress.

To get a mesh pattern like my other bottom case (https://www.printables.com/model/728922-datto-alto-3-v2-replacement-case-bottom-40mm-screw), in your slicer:

• Remove the top & bottom layers
• Infill of 15%
• Infill lines = 3 (Cura settings “Infill Line Multiplier”)